IP Policy Routes Help

The IP Policy Routes allow IP packets forwarding to the specified router depending on the source IP address as well as to set the priority for the current routing rule.

The IP Policy Routes table displays all created IP policy routes with their parameters: Target State for the state of the route (enabled or disabled), Actual State for the state of the route connection (up, down or erroneous), Priority for the route priority, Route From is where the subnet routed packets comes from and Via IP Address is where the router IP address incoming packets should be routed through.

The Add button opens the Add IP Policy Route page where a new policy route can be created. The Add IP Policy Route page consists of the following components:

• The Priority text field requires the digit value (from 1 to 252) for the priority of the routing rule. Less is the priority, sooner the routing rule will take effect.
• The From text fields require the packet source IP address and subnet mask of the specified destination to match with the rule.
• The Via IP address text fields require the IP address of the router the IP packet will be forwarded to.

The IP Clipboard buttons offers a conveniant possibility to enter IP addresses that have been used before.

Edit opens the Edit Entry page where existing IP Policy Routes can be edited.
Delete removes the selected IP Policy Routes from the IP Policy Routes table.
The Enable and Disable buttons are used to activate/deactivate the selected route(s).
The Raise Priority and Lower Priority functional buttons are used to increase or decrease the priority of the selected IP Policy Route(s) by 1. At least one route should be selected to use these functions, otherwise an error message "No record(s) selected." will appear.
Select all selects all records in the table.
Inverse selection inverses the current selection (if no records are selected, clicking on inverse selection will check all records).