Caller ID Based Services for Address page allows to configure Caller ID Based
services for the corresponding extension depending on certain address. Page consists of two frames.
In the left frame all Caller ID Based services are listed. Clicking on the corresponding
Caller ID Based service, its settings will be displayed in the right frame.
Following Caller ID Based Services can be configured from this page:
Hiding Caller Information - used to suppress the transmission of QX1000 user information depending on the called destinations.
Distinctive Ringing - used to assign different ringing patterns to individual callers.
Call Hunting - used to configure the consecutive ringing on several extensions for incoming calls from certain specified callers.
Many Extension Ringing - used to define parallel ringing on several extensions for incoming calls from certain specified callers.
Unconditional Call Forwarding - used to configure unconditional transfer of different incoming calls to varying extensions.
Busy Call Forwarding - used to configure transfer of different incoming calls to varying extensions when called destination is busy.
No Answer Call Forwarding - used to configure transfer of different incoming calls to varying extensions when called destination does not answer. No answer timeout should be configured from the Basic Services - General Settings page.
Unregistered/Inaccessible Call Forwarding - used on extensions attached to IP lines only and allows to configure transfer of different incoming calls to varying extensions when the called IP phone is not registered on the QX1000 or when it is unreachable.
Intercom - used to call an extension by forcing it to go off-hook and opening two-way communication.
Find Me/Follow Me - used to configure simultaneously or subsequently ringing destinations on the incoming call from the certain caller.
Emergency Interrupt - used to interrupt the active calls in case of emergency.
Voicemail Profile - used to define and configure voice mail profiles.
Note: Remember to save changes before moving between the caller ID based services configuration pages.