The Diagnostics page gives a possibility of running Network protocol diagnostics to verify QX1000's connectivity and to download all system logs for possible problems recovery.
The Start Network Diagnostics button is used to initiate network diagnostics, i.e to check the WAN link and IP configuration, to verify gateway, DNS primary and secondary (if configured) servers' accessibilities.
The Reboot this Device button is used to reboot the QX1000. Please note, that the session with the QX1000 will be closed, i.e. QX1000 GUI should be newly opened and new login will be required afterwards.
The Download system logs button is used to download all logs to the local PC as a *.tar archive file. Logs can be used by Epygi Technical Support Office to determine the problem occurred on your QX1000.
The field below will display the diagnostics results and the connectivity conditions. System should be reconfigured if problems occur during the diagnostics.
The Show System Logs link leads to the page where QX1000's logs might be viewed, downloaded and the logging setting may be adjusted.
The System Logs Archive link leads to the page where an automatically collected system logs can be managed. System logs archive starts automatically each time you run QX1000 since last reboot.