PPTP/L2TP Routes Help

The PPTP/L2TP Routes allow IP packets forwarding through the PPTP and L2TP tunnels of the Quadro. If PPTP/L2TP connections do not exist on Quadro, VPN routes cannot be generated.

The PPTP/L2TP Routes table displays all created VPN routes with their parameters: Target State for the state of the route (enabled or disabled), Actual State for the state of the route connection (up, down or erroneous), Route To for the subnet where the incoming packets should be routed, Via Tunnel for the VPN tunnel incoming packets should be routed through and Tunnel State for the actual state of the route tunnel (up or down).

The Add functional button opens the Add VPN Route page where a new VPN route can be created. The Add VPN Route page consists of the following components:

• The Route Via drop down list contains the available PPTP and L2TP connections on the Quadro. Connection selected from this list will be used to route the IP packet from the Quadro's LAN to the peer behind the PPTP/L2TP tunnel.
• The Route To text fields require the IP address range of the possible peers behind the PPTP/L2TP tunnel IP packets could be routed to.
The IP-Clipboard buttons offers a conveniant possibility to enter IP addresses that have been used before.

Edit opens the Edit Entry page where the existing VPN route can be edited.
Delete removes the selected VPN routes from the VPN Routes table.
The Enable and Disable buttons are used to activate/deactivate the selected route(s). At least one route should be selected to use these functions, otherwise an error message appears: "No record(s) selected."
Select all selects all records in the table.
Inverse selection inverses the current selection (if no records are selected, clicking on inverse selection will check all records).